The eyes need some work. I had to remove the yellow and it made it better. Im going to try to paint a hair of it to make it look slightly better. but yeah the eyes are the only issue

The blly badge has a lot of background bleed through.

There is no 3mf file or stl.

There are random red artifacts spread throughout the white belly area. Using a .4 nozzle and .2 layer height. Artifacts show up in both Bambu Slicer and Snapmaker Orca Slicer. Random artifacts are on layer 32, 39, 46, 47, 76, 90, 118, 127, 130, 131, 136, and 143 in both slicers using those settings.

Moon isn’t colored right.

Top of the eyes aren’t fully colored in.

Beak doesn’t print properly.

His teeth are too thin come off with support

Yeah its printing hollow.

has a brown line through the red jumpsuit

Inner desgin is not printing correct

Website showed I could buy the file. I purchased the file for $15.00. But, when I went to the download hub it shows there are no files to download.

Slicing error, apparent gap in model. Scaled to 55mm

The mask does not print. Size was 35mm. I was printing an entire plate and all of them failed in this spot

There is no printable file attached to the ZIP

Bought from the store and it isn't finished/colored. I was hoping to print it right away,.

Not a printing error but the 3MF file that says it's the colored version is just a single color version. I checked the no color version just in case and it is also just a single color

I printed the new Darth vader and the cape didn't stay in place and then attach to 8 of the 9 ducks on the plate. Maybe not enough supports?

I don't know if its suppose to be this way but Daphne neck scarf thing does't connect with the model until about halfway up. There are no supports unless I place them myself. So I printed half a duck and learned this and put the supports on myself. I also notice the hair isn't a solic piece. its hollow. Just a lot different than any other duck I've printed.

Glasses are too thin; if printed at 3 inches or smaller, they break.